Thermador HPCN36NS Installation Manual download pdf (Page 18)

English 16

Chimney Extension

Installation (optional)

Optional chimney extensions and telescoping extensions

are used to fill the space between the hood and ceiling

(available for separate purchase). Chimney extensions fill

the space between the hood and ceiling of 8' (2.4 m) and 9'

(2.7 m) ceilings. Telescoping extensions accommodate 10'

(3 m) ceilings. For dealer information, visit the Find a

Dealer section on our website at www.thermador.com.

Chimney Extension Installation

IMPORTANT NOTE: Secure the Chimney Hood to the wall

before installing the Chimney Extension. See “Hanging the

Chimney Hood” on page 11 before securing the actual

Extension.

1. Installation of the chimney hood should maintain a

minimum height of 30" (762 mm) from the bottom of the

hood to the cooking surface. To determine placement

of the hood with a Chimney Extension, the height of the

chimney extension must be calculated (see

“Calculating Optional Duct Cover Height” on page 9).

2. From inside of hood, screw the supplied 5/8” (16 mm)

sheet metal screws through the holes on each side and

along the front into bottom of the extension, as shown

in Figure 21. (Screw quantity is dependent on hood

size.)

Telescoping Chimney Extension

Installation

IMPORTANT NOTE:

Secure the Chimney Hood to the wall after installing the

Extension Mounting Bracket, but before installing the

Telescoping Chimney Extension. See “Hanging the

Chimney Hood” on page 11 before securing the actual

Extension.

Securing the Telescoping Chimney Extension Bracket

1. Ensure that the minimum height of 30" (762 mm) from

the bottom of the hood to the cooking surface will be

maintained (see “Calculating Optional Duct Cover

Height” on page 9).

2. Locate two studs at the mounting location, as shown in

Figure 22.

3. At the wall stud locations, measure ǫ” (16 mm) down

from the ceiling to the top of the bracket.

MODEL 6” EXTENSION 12” EXTENSION

HPCN36NS CHMHP366N CHMHP3612N

HPCB36NS CHMHP366N CHMHP3612N

HPCN48NS CHMHP486N CHMHP4812N

HPCB48NS CHMHP486N CHMHP4812N

Figure 21: Attachment of Chimney Extension to Hood

measurements in inches (mm)

Figure 22: Hood Location

18” (457)

18” – 35”

( 457 – 889)

18” – 35”

( 457 – 889)

18” – 35”

( 457 – 889)

⅝” (16)

18”

(457)

18”

(457)

18”

(457)

17”

(432)

17”

(432)

17”

(432)

36" 14" (356) 20¾" (527)

48" 14" (356) 32⅞" (835)

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 62 63

Comments to this Manuals

No comments

Thermador HPCN36NS Installation Manual Page 18

Comments to this Manuals

Related products and manuals for Cooker hoods Thermador HPCN36NS