Thermador HPCN36NS Installation Manual download pdf (Page 10)

English 8

Electrical Requirements

The unit requires a 120V AC, 60Hz. 15A branch circuit.

The hood should only be connected to a dedicated circuit

(with ground) that has been installed according to relevant

regulations.

When connected to a GFCI-protected supply,

THERMADOR PROFESSIONAL hoods are suitable for

use in damp locations that are protected from outside

weather conditions and not subject to saturation with water

and other liquids, but can be subject to moderate degrees

of moisture (such as an outdoor covered patio or lanai

area). Refer to local codes, NEC/CEC, and or the Authority

Having Jurisdiction (AHJ) for additional information.

Check your local building codes for proper method of

installation. In the U.S., if there are no applicable local

codes, this unit should be installed in accordance with the

National Electric Code ANSI/NFPA No. 70, Current Issue.

In Canada, installation must be in accordance with the CAN

1- B149.1 and .2 - Installation Codes for Gas Burning

Appliances and/or local codes.

The appliance must be grounded. In the event of an

electrical short circuit, grounding reduces the risk of electric

shock by providing a wire that allows the electric current to

escape.

Electrical Data on the Data Rating Plate:

Data, including the model and serial number, is located on

the product data rating plate inside the appliance, visible

after removal of the filter frame (see Figure 29 on page 19).

Hood Transition

Assembly of the Transition:

The overall height of the transition is 8Ǫ" (212 mm). The

hood transition sits 6½” (165 mm) above the top of the

hood. 1Ǭ" will mount below the top edge of the hood. See

Figure 4 on page 9 for overall hood dimensions.

1. Align mounting holes at base of transition with the

mounting holes of the ½” (13 mm) flange located at the

top.

2. Fasten transition to hood using (4) 1” (25.4 mm) sheet

metal screws, included with hood.

3. Seal connection between transition and hood with

aluminum tape.

4. Remove tape holding damper closed.

CAUTION!

This range hood must be properly grounded. The unit

should be installed by a qualified electrician in

accordance with all applicable national and local

electrical codes.

WARNING!

The appliance must be grounded.

Figure 3: Transition Connection

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 62 63

Comments to this Manuals

No comments

Thermador HPCN36NS Installation Manual Page 10

Comments to this Manuals

Related products and manuals for Cooker hoods Thermador HPCN36NS