Thermador PRDS36 User Manual download pdf (Page 13)

STEP 4: INSTALLING ANTI-TIP DEVICE

Parts Required for Installation of Anti-Tip Device:

PRG304 and PRG36 All Gas Ranges (Figures 9 and 10)

15-10-948 (2 Each)

15-10-910 (1 Each)

15-10-911 (2 Each)

15-10-771 (1 Each)

15-10-916 (4 Each)

15-10-772 (1 Each)

15-10-909 (1 Each)

Mounting Bracket

FIG. 9 Mounting Kit for PRG304 and PRG36

All-Gas Ranges

PRDS304 and PRDS36 Dual

Fuel Ranges (Figure 11)

Thermador Part No. Qty Description

15-10-916 4 Screw, Phillips,#10 x 1-1/2"

15-10-770 1 Anti-Tip Channel, Adjustable,

IMPORTANT INSTALLATION INFORMA-

TION:

• The anti-tip bracket may be attached to a

solid wood cabinet having a minimum wall

thickness of 3/4".

• The thickness of the wall or floor may

require use of longer screws, available at

your local hardware store.

• In all cases, at least two (2) of the bracket

mounting screws must be fastened to solid

wood or metal.

• Use appropriate anchors when fastening the

mounting bracket to any material other

Thermador Part No. Qty Description

15-10-916 4 Screw, Phillips,#10 x 1-1/2"

15-10-771 1 Anti-Tip Channel, Adjust

able, PRG

15-10-772 1 Mounting Bracket, PRG

15-10-909 1 Bolt, Hex Head, 1/4"-20 x

1/2"

15-10-910 1 Nut, Hex, 1/4-20

15-10-911 2 Washer, Flat, 1/4-20

15-10-948 2 Screw, Phillips, #10 x 1/2"

1-17/32"

1-9/32"

5-1/2"

This Hole

For Flush

Mount of

PRG36

This Hole

For Flush

Mount of

PRG304

FIG. 10 Adjustable Anti-Tip Channel PRG304

and PRG36 All-Gas Ranges

FIG. 11 Mounting Kit for PRDS304 and PRDS36

Dual Fuel Ranges

15-10-770 (1 Each)

15-10-916 (4 Each)

than hardwood or metal.

• Prepare holes at fastener locations as

identified below:

- For walls, wall studs, or floors composed

of solid wood or metal, drill 1/8" pilot

holes.

- For walls or floors composed of drywall,

sheet-rock or other soft materials, drill 3/

16" holes to a minimum depth of 1-3/4",

then tap plastic anchors into each of the

holes using a hammer.

- For walls or floors composed of concrete or

concrete block, drill 3/16" holes to a

minimum depth of 1-3/4", then tap con

crete anchors into each of the holes using

a hammer.

- For walls or floors having ceramic tile

covering, drill 3/16" holes through the tile

only, then drill into the material behind

the tile as indicated immediately above.

• If the range is moved to a new location, the

Anti-Tip Device must be removed and rein-

stalled.

Page 11

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Comments to this Manuals

No comments