Thermador PRDS36 User Manual download pdf (Page 10)

• The range has an approximate

shipping weight as shown in

Chart A. It is recommended that

the door(s), grates, burner caps,

front kick panel and oven racks be

removed to facilitate handling.

This will reduce the weight as

shown in Chart A and allow the

range to pass through 30" door-

ways. See Chart B and Fig. 2a and

2b. Do not remove the grill or

griddle assemblies.

• Remove the outer carton and

packing material from the ship-

ping base. Remove the front kick

panel (see Fig. 4) by removing two

(2) screws at the top and pulling

forward. The dual fuel ranges are

held to the skid by four (4) bolts,

the front two (2) are behind the

kick panel (see Fig. 4) and the

rear two (2) are located on the

bottom flange of the range back

(see Fig. 5). All-gas ranges are

held in place by 4 bolts, two (2)

as shown in Fig. 4 and two (2) at

the rear as shown in Fig. 5. After

removing the bolts the range

must be lifted and removed from

the skid.

• To remove the door, open the

door to the fully open position.

Close the hinge latches (See Fig.

6) by rotating towards the door

top. The door can then be re-

moved by gently lifting and

pulling the door, with the hinges

up and out of the frame. Do not

lift the range by the door

handle(s).

Chart A 30" Range 36" Range 48" Range

Shipping Weight 335 lbs. 444 lbs. 584 lbs.

Weight without 285 lbs. 390 lbs. 524 lbs.

packing materials

After removing door(s), 215 lbs. 295 lbs. 395 lbs.

burner caps, front kick

panel and oven racks

Chart B 30" Range 36" Range 48" Range

Doorway Width Required 28-7/8" 30-7/8" 30-7/8"

(Unit Assembled)

Doorway Width Required 27-3/4" 29-1/2" 29-1/2"

(Oven Door(s) Removed)

Proper equipment and

adequate manpower must

be used in moving the

range to avoid damage to

the unit or the floor. The

unit is heavy and rests on

adjustable steel legs.

CAUTION:

FIG. 4 All Ranges – Removal of

Kick Panel and Two Front

Shipping Bolts

FIG. 5 All-Gas and Dual Fuel

Ranges –Removal of Two Rear

Shipping Bolts

➛

Left Rear

Shipping

Bolt

Front

Kick

Panel

FIG. 6 All Ranges –

Door Removal

STEP 3: UNPACKING, MOVING AND PLACING THE RANGE

Hinge Clip In

Locked Position

Lower Clip After

Replacing Door

Hinge Latch

Page 8

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Comments to this Manuals

No comments