Thermador PRG364NLH Installation Manual Page 13

  • Download
  • Add to my manuals
  • Print
  • Page
    / 85
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 12
English 10
Moving the Range
Due to the weight, a furniture dolly with soft wheels or an
air lift should be used to move this unit. The weight must be
supported uniformly across the bottom.
NOTICE:
The electric wire diagrams and schematics are attached
behind the kick panel, and should not be removed except
by a service technician, then replaced after use.
Removing the Pallet Bolts
1. To remove the (4) pallet bolts in the front and in the
back, use a 7/16” wrench or ratchet and socket to
remove the pallet bolt from the bottom of the pallet.
Discard the wood packing block inserts.
2. Lift range and remove it from the pallet.
Use additional
help as required to remove from pallet.
3. Transport the range by dolly close to its final location.
Unit should not be dollied from the front.
4. The range can then be tipped back and supported on
the rear legs while the dolly is carefully removed. THE
FLOOR UNDER THE LEGS SHOULD BE
PROTECTED BEFORE PUSHING THE UNIT INTO
POSITION.
Step 4 through Step 8 must be completed before
the range is placed in its final position. For proper
performance, the range must be level. See
“Step 9: Placing and Leveling the Range” on
page 22 for leveling instructions.
CAUTION!
DO NOT lift the range by the oven door’s
handle, as this may damage the door hinges
and cause the door to fit incorrectly.
DO NOT lift the appliance by the range’s
control panel.
The unit is heavy and should be handled
accordingly. Proper safety equipment such as
gloves and adequate manpower of at least
two people must be used in moving the range
to avoid injury and to avoid damage to the
unit or the floor.
Rings, watches, and any other loose items
that may damage the unit or otherwise might
become entangled with the unit should be
removed.
Hidden surfaces may have sharp edges. Use
caution when reaching behind or under
appliance.
DO NOT use a hand truck or appliance dolly
on the back or front of the unit. Handle from
the side only.
Figure 6: Removal of Shipping Bolts
Page view 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 84 85

Comments to this Manuals

No comments