Thermador PRG364NLH Installation Manual download pdf (Page 18)

English 15

Step 6: Electrical Requirements, Connection & Grounding

Before installing, turn power OFF at the service panel.

Lock service panel to prevent power from being turned

ON accidentally.

For these gas range models, a neutral supply wire must be

provided from the power source (breaker) because critical

range components, including the surface burner spark

reignition modules, require 120 VAC to operate safely and

properly.

If the correct power supply circuit is not provided, it is the

responsibility and obligation of the installer and user to

have proper power supply connected. This must be

accomplished in accordance with all applicable local codes

and ordinances by a qualified electrician. In the absence of

local codes and ordinances, the power supply connection

shall be in accordance with the National Electrical Code.

Observe all governing codes and ordinances when

grounding. In the absence of these codes or ordinances

observe National Electrical Code ANSI/NFPA No. 70

current issue. Electric wiring diagrams and schematics

have been placed in the kick panel area of the range for

access by a qualified service technician (refer to Figure 23

on page 22).

Before you plug in an electrical cord, be sure all controls

are in the OFF position.

Do not cut or remove the ground prong. It must be plugged

into a matching grounding type receptacle to avoid

electrical shock. If there is any doubt as to whether the wall

receptacle is properly grounded, the customer should have

it checked by a qualified electrician.

INSTALLER — show the owner the location of the circuit

breaker. Mark it for easy reference.

IMPORTANT:

Dedicated 20 AMP service is required for ranges with an

electric griddle or grill.

MODEL

TYPE

VOLTAGE

CIRCUIT

RATING

FREQUENCY PHASE

30" 120 VAC 10 Amps 60 Hz. Single

36" 120 VAC 10 Amps 60 Hz. Single

36” with griddle 120 VAC 20 Amps 60 Hz. Single

36” with grill 120 VAC 20 Amps 60 Hz. Single

48” with griddle 120 VAC 20 Amps 60 Hz. Single

48” with grill 120 VAC 20 Amps 60 Hz. Single

Table 2: Electrical Supply Circuit Requirements

WARNING!

An improper 120 VAC power supply will cause

malfunction, damage to this appliance, and possibly

create a condition of shock hazard.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 84 85

Comments to this Manuals

No comments

Thermador PRG364NLH Installation Manual Page 18

Comments to this Manuals

Related products and manuals for Cookers Thermador PRG364NLH