Thermador VCIN36JP Installation Manual Page 15

  • Download
  • Add to my manuals
  • Print
  • Page
    / 96
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 14
English 13
Wiring the Hood with a
Remote Blower
Custom insert models can be installed with remote blowers
(
VCIN models). For complete installation instructions see
the instructions supplied with the blower unit.
1. Remove junction box channel covering the wires (see
Figure 5 on page 11).
2. Remove circular knockouts (Figure 5 on page 11).
3. Install 1” (25.4 mm) conduit connectors.
4. Run black, white, and green wires (#12 AWG) in 1”
(25.4 mm) conduit from the power supply to the
junction box.
5. Connect the power supply wires to the hood wires in
the following order: black to black, white to white, and
green wire to green ground screw on chassis. Use
spring type wire nuts supplied.
Lost or missing wire nuts should only be replaced
with spring type wire nuts, rated for a minimum of
two (2) #18 gauge wires and maximum of four (4)
#14 gauge wires, UL & CSA rated to 600V and
302°F (150°C).
6. Connect the “pigtail” to the connector inside the
junction box.
7. Run five (5) #14 AWG wires in 1” (25.4 mm) conduit
from the remote blower to the second conduit
connector.
8. Connect the remote blower to the pigtail wires as per
Figure 9. Connect the remote blower green (ground)
wire to the ground screw in the junction box. Refer to
the blower installation instructions for further wiring
details.
9. Close the junction box cover.
Figure 8: VTR1330E Remote Blower
Figure 9: Wiring the Hood with a Remote Blower
19
7/
8
"
(505 mm)
2
1/
8
"
(54 mm)
10"
(254 mm)
2
1/
8
"
(54 mm)
20
3/
4
"
(527 mm)
12
7/
8
"
(327 mm)
12
1/
8
"
(308 mm)
6
1/
2
"
(165 mm)
1
7/
8
"
(48 mm)
13
5/
8
"
(346 mm)
dia. 9
7/
8
"
(251 mm)
Page view 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 95 96

Comments to this Manuals

No comments