Thermador VCIN36JP Installation Manual download pdf (Page 14)

English 12

Wiring the Hood with an

Integral Blower

Integral Blower models VTN630C and VTN1030C are

integrated into the hood at the time of installation (

VCIN

models). For complete installation instructions see the

instructions supplied with the blower unit.

1. Remove junction box channel covering the wires (see

Figure 5 on page 11).

2. Remove circular knockouts (Figure 5 on page 11).

3. Connect the blower’s Molex plug connector to the

connector present inside the hood, as shown in

Figure 7.

4. Install 1” (25.4 mm) conduit connector in junction box.

5. Run black, white, and green wires (#12 AWG) in 1”

(25.4 mm) conduit from the power supply to the

junction box.

6. Connect the power supply wires to the hood wires in

the following order: black to black, white to white, and

green wire to green ground screw on chassis. Use

spring type wire nuts supplied.

• Lost or missing wire nuts should only be replaced

with spring type wire nuts rated for a minimum of

two (2) #18 gauge wires and maximum of four (4)

#14 gauge wires, UL & CSA rated to 600V and

302°F (150°C.)

7. Close the junction box cover.

Figure 6: Integral Blower Model VTN1030C

Figure 7: Wiring the Hood with an Integral Blower

(57 mm)

25"

(635 mm)

(171 mm)

(225 mm)

" (210 mm)

(175 mm)

(105 mm)

From Control Panel

From Blower

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 95 96

No comments

Thermador VCIN36JP Installation Manual Page 14