Thermador HMWN36FS Installation Manual download pdf (Page 9)

HOOD W IDTH DIM. "W " DIM. "K " DIM. "Z"

30" 29 - 1/8" 2 - 1/2" 7 - 1/16"

36" 35 - 1/16" 2 - 1/2" 7 - 1/16"

48" 47 - 1/16" 2 - 1/2" 7 - 1/16"

Table 3

Side slot x 4

Figure 4b

Figure 4a

Wall Mount Installation

Note: see below if cabinet installation is preferred

3. After the hood installation height has been

determined draw a horizontal line at a distance

above the cooktop equal to the desired hood

installation height plus 7- 1/2”. See also Figure 4a.

4. Find the centerline of the cooktop. Draw a

vertical line along this centerline up to the hori-

zontal line drawn in step 1 and draw a vertical

line right and left at a distance of12-5/8” to

determine the mounting location of the

mounting hooks shipped with the hood.

5. Fit two mounting hooks on the wall to hang the

hood through the provided slots (2 wall

anchors + 2 hooks + 2 screws 5x35).

6. Run 10” Duct, long enough to reach the

transition once the hood has been installed plus

1 1/2” inch to connect ductwork. Fix Duct to

transition with screws and seal withtape.

7. Remove 1 of 2 knockouts and install 1/2”

conduit connector in j-box.

8. Hang the hood and adjust its position through

the screws on the hooks.

9. Fix the hood to 4 additional point, 2 on

upperside, 2 on lower side (use 4 wall anchors

+ 4washers + 4 screws 5x35).

Cabinet Installation:

Note: See above if wall mount installation is preferred

Note: Distances on Table 3.3.

Find the centerline of the cabinet bottom. Draw a line

along this centerline from rear to front of the cabinet.

See also Figure 4b.

4. Draw two lines, one at a K distance from the wall,

the other one at a Z distance from the previous line.

Mark 4 points, two along each line at a distance of

half W from the center line, to determine the screw

locations.

5. Fit 4 screws on cabinet bottom do not tighten

completely but leave a space of about 1/2” from

cabinet bottom surface and head screws.

6. Run 10” Duct, long enough to reach the transition

once the hood has been installed plus1 1/2” inch for

connect ductwork.

7. Remove 1 of 2 knockouts and install 1/2”conduit

connector in j-box.

8. Hang the hood on screws through side slots provided

on hood top. Tighten the four screws. Note: If possible

x the hood on the wall at 4 additional point (2 on

upper side, 2 on lowerside).

9. From the inside of the cabinet attach the transition

on upper outlet.

Center Hole

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 34 35

Comments to this Manuals

No comments

Thermador HMWN36FS Installation Manual Page 9

Comments to this Manuals

Related products and manuals for Cooker hoods Thermador HMWN36FS