Thermador HMWN36FS Installation Manual download pdf (Page 12)

12

REMOTE VENTILATOR

INSTALLATION

HMWN30/36/48 Series Hood:

Figure 8

Connector in the

internal body panel

ELECTRICAL PIGTAIL DETAILS

The pigtail is congured to be connected

as is described in the following table.

FUNCTION COLOR

Speed 1 Red

Speed 2 Blue

Speed 3 Orange

Speed 4 Brown

Common White

The hood is designed to work with

Thermador’s remote and in line

ventilator rated with a maximum

corrent absorbtion of 8.5 Amp.

(see list under paragraph “Parts Not

Included with your Hood”) For

installation instructions see the

instructions supplied with the

ventilator unit.

Wiring the Hood with a Remote or in

line Ventilator:

Warning: Turn o electricity at the

service panel before wiring the unit.

1. Remove the j-box cover as shown

in Figure 8.

2. Remove cover T from the j-box.

3. Remove the 2 knockouts and

install 1/2” conduit connectors.

4. Run black, white, and green wires

(#14AWG) in 1/2” conduit

5. Connect black, white, and green

green wires from power supply

to black, white and green/ yellow

wires in j-box respectively.

6. Connect wire clamp to “pigtail” as

shown in Figure 12. Insert “pigtail”

wire into j-box and x wire clamp

to j-box using nut supplied with

clamp V.

7. Run ve wires (14AWG) in 1/2”

conduit from the remote blower

to the second conduit connector.

8. Connect the wires coming from

pigtil to the wires from external

blower according with the following

table.

9. Close junction box cover. Check

that all ligth bulbs are secure in

the soclets. Install lters. Turn

power on at service panel, and

check ligths and blower operation

per Care & Use section of this manual.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 34 35

Comments to this Manuals

No comments