11
Wiring the HOOD with an
Integral Ventilator:
Figure 7
Motor Connector
Warning: Turn o electricity at
the service panel before wiring the
unit.
1. Connect the Integral Ventilator
molex plug connector to the
connector present inside the
hood as shown in Figure 6.
2. Remove the j-box cover as
shown in Figure 7.
3. Remove 1 of 2 knockouts and
install 1/2” conduit connector
in j-box.
4. Run black, white, and green
wires (#14 AWG) in 1/2”conduit
from power supply to j-box.
5. Connect black, white, and
green wires from power supply
to black, white, and green/
yellow wires in j-box
respectively.
6. Close j-box coover.
7. Turn power on at service panel.
Check operation of the hood.
Power supply conduit
Figure 6
Comments to this Manuals