Thermador HMWN36FS Installation Manual download pdf (Page 5)

Parts In cluded with your Hood

t Hood Canopy Assembly without blower

t Grease lters

t Drip tray for each lter.

t Use & Care / Installation Instructions

t Fittings bag with:

t Drip trays holding brakets + plastic washers and

knobs

4 Washers

6 Drywall anchors

2 Hooks with regulating screws

6 Screws 5X35

4 Screws for transition

t 1 Transition withback draft damper

Option al accessory

Duct covers only for 30” and 36”

Ductless recirculation kit available only for HMWN30

HMWN36 model.

Parts Not Included with your

Hood

t Duct Tape

t 1/2" Conduit

t Wire Nuts

t Round Duct.

t Wiring clamp

CAUTION! Lamps are not supplied, use

ONLY 120 Volt, 50 Watt (maximum) 50°

halogen light made or a GU10 base,

suitable for use i n open luminarie .

t 4 #10 pan head wood screws for installation on

a bottom of a cabinet

Tools required

Flat blade and Phillips screwdrivers

Pencil and tape measure

Metal snips (in some applications)

Electric drill

Saw (saber or keyhole)

Pliers

Level

Caulking

Flashlight

Wire s

tripper

Safety glasses

Gloves

Step ladder

INSTALLING THE HOOD

t For the most ecient air flow exhaust, use a

straight run or as few elbows as possible.

CAU TIO N: Vent unit to outside o f

building, only.

t Two people are necessaryfor installation.

On average 2 hours are necessary to complete

installation (without considering cut to be done

on wall and or on cabinet, installation of ducts ,

conduit and electrical connections to the mains) .

installation steps:

11 installation steps are required for both

installation methods

Wall mount installation steps or in alternative

Cabinet installation

t The hood is tted with Screws and Drywall

Anchors suitable for most surfaces, consult a

Qualied Installer, check if they perfectly f it with

your cabinet/wall.

t Do not use ex ducting.

t COLD WEATHER installations should have an

additional backdraft damper i nstalled to

minimize backward cold air ow and a

nonmetallic thermal break to minimize

conduction of outside temperatures as part of

the ductwork. The damper should be on the

cold air side of the thermal break.

The break should be as close as possible to

where the ducting enters the heated portion of

the house.

t Make u

air: Local building codes may require

the use of Make-Up Air Systems when using

Ducted Ventilation Systems greater than

specied CFM of air movement.

The specied CFM varies from location to location.

Consult your HVAC professional for specic

requirements in your area.

3 prong plug

Blowers

See sections for integral ventilator installation and remote

ventilator installtion for more blower details.

1 2 3 4 5 6 7 8 9 10 ... 34 35

Comments to this Manuals

No comments

Thermador HMWN36FS Installation Manual Page 5

Comments to this Manuals

Related products and manuals for Cooker hoods Thermador HMWN36FS