Thermador PRG366JG Installation Manual download pdf (Page 15)

English 13

Important Installation Information:

• The anti-tip bracket may be attached to a solid wood

cabinet having a minimum wall thickness of 3/4”

(19mm).

• The thickness of the wall or floor may require use of

longer screws, available at your local hardware store.

• Use appropriate anchors when fastening the mounting

bracket to any material other than hard-wood or metal.

• In all cases, at least (2) of the bracket mounting screws

must firmly fasten the anti-tip bracket to the floor, and

(2) of the mounting screws (or drywall anchors) must

firmly fasten the anti-tip bracket to the rear wall (see

Figure 8 and Figure 9).

Mounting the Anti-Tip Bracket

1. Prepare holes at fastener locations as identified below:

• For walls, wall studs, or floors composed of solid

wood or metal, drill 1/8” (3.17mm) pilot holes.

• For walls or floors composed of drywall, sheet-

rock or other soft materials, drill 3/16” (4.76mm)

holes to a minimum depth of 1

” (44mm), then tap

plastic anchors into each of the holes using a

hammer.

• For walls or floors composed of concrete or

concrete block, drill 3/16” (4.76mm) holes to a

minimum depth of 1

” (44mm), then tap concrete

anchors into each of the holes using a hammer.

• For walls or floors having ceramic tile covering,

drill 3/16” (4.76mm) holes through the tile only, then

drill into the material behind the tile as indicated

immediately above.

• Place bracket on floor near the center of where the unit

is to be finally located (shown in Figure 8).

• If the range is moved to a new location, the Anti-Tip

Device must be reinstalled.

2. Secure bracket into the wall stud and to the floor using

the screws provided.

3. Later, when the unit is installed, the adjustable legs will

allow the cast base to slide under the bracket hook,

stabilizing the unit.

FIGURE 8: ANTI-TIP BRACKET MOUNTING LOCATION

3”

(76mm)

FIGURE 9: ANTI-TIP BRACKET

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 95 96

Comments to this Manuals

No comments

Thermador PRG366JG Installation Manual Page 15

Comments to this Manuals