Thermador PRG366JG Installation Manual download pdf (Page 22)

English 20

1. Tape the templates included with the Keep Hot Shelf to

the wall accordingly:

• Tape the sheet titled Left Hand Template to bottom

and left end of hood. Align the bottom line of hood

with the top line of the template.

• Tape the sheet titled Right Hand Template to

bottom and right end of hood. Align the bottom line

of hood with the top line of the template.

• Tape the sheet titled Installation Instruction so that

the arrow at the top of the template aligns with

hood centerline. Align the bottom line of the hood

with the top line of the template.

• Left to right sides of the template must be equal to

length of shelf.

2. Mount the (2) top shelf brackets and the (3) lower shelf

brackets at the locations outlined on the templates.

Secure with the (10) 1” (25.4mm) screws provided.

3. Cut template out from around the brackets and remove

from the wall. Do not discard template before the Keep

Hot Shelf is completely installed.

4. Insert the (3) U-Nuts onto the (3) lower shelf brackets.

5. Install the wall plate by setting the corner notches

(back of wall plate) atop the (2) top shelf brackets.

Slide the shelf upwards until the bottom engages with

the (3) lower brackets (Figure 15).

6. Check if the top is properly secured by pulling the top

section of the shelf from the wall.

7. Secure to bottom of shelf with the (3) 1/2” (12.7mm)

screws provided.

For 48” Keep Hot Shelf

Follow steps 1-6 except use (4) lower brackets which must

be spaced equally 15” (381mm) center-to-center.

Figure 15: 48” Back of Wall Plate

Upper shelf bracket (x2)

Lower shelf bracket (x4)

Notches (x2)

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 95 96

No comments

Thermador PRG366JG Installation Manual Page 22