Thermador PRG366JG Installation Manual download pdf (Page 13)

English 11

To Reinstall the Oven Door:

1. Position the door at a sharp angle (see Figure 7) and

insert the hinges centered evenly into the hinge slots.

The hinges will securely hook into the slots when

properly installed. Do not force, bend, or twist the door.

• Tip: Rest the door on your foot while using your leg

for stability.

2. Open the door fully and use a screwdriver to push the

hinge clips all the way into the hinge slots (toward the

oven) until they meet the hinge. Be careful not to

scratch the range during this process.

To Check Door Fit and Operation:

1. Open and close the door slowly to test the movement

and the fit of the door to the oven cavity. Do not force

the door to open or close. If the door is properly

installed, it should move smoothly and rest straight on

the front of the range when closed.

2. If the door does not operate correctly, verify that the

hinges are properly seated into the hinge slots, and

that the hinge clips are fully engaged into the slots.

3. If door or handle appears slightly tilted, you may adjust

the hinge receiver by rotating the large Torx-head

screw located directly above the hinge receiver with a

T-20 Torx driver. Turn adjustment screw until door is

aligned (Photo D).

FIGURE 7: APPROXIMATE DOOR ANGLE FOR REMOVAL

23°

Turn this

screw to

adjust door

alignment

Photo D

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 95 96

No comments

Thermador PRG366JG Installation Manual Page 13