Thermador PRD484NCGU Installation Manual Page 29

  • Download
  • Add to my manuals
  • Print
  • Page
    / 94
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 28
English 26
Griddle Tilt Adjustment (not all models)
If the range is equipped with an electric griddle, check the
griddle frame adjustment by pouring two tablespoons of
water on the back of the griddle plate. The water should
slowly roll into the grease tray. If not, adjust the two screws
under the back of the frame. Start with one half turn
counterclockwise (CCW) of the screws. Further adjustment
should be made by one-quarter turn until water slowly flows
into the grease tray.
Assembling the Grill (not all models)
Refer to “Using the Electric Grill” in the Use and Care
Guide.
Installing the Leg Covers
1. Remove plastic coverings from the stainless steel
covers.
2. Place the smaller cover, with cutouts facing up, inside
the larger cover with the openings of both stacked and
facing the back.
3. Beneath the range, wrap the cover assembly around
the leg.
4. Slide the outer cover up while the inner piece remains
on the floor. The mating part has dimples for which the
holes of the larger cover should seize. You should feel
a definitive click, letting you know that the cover
assembly has been mounted to the unit.
Figure 32: Griddle Leveling Screws
WARNING!
To avoid risk of injury, never operate griddle without the
griddle plate installed. Never use griddle in a manner
that is not prescribed by the Use and Care Manual.
The griddle plate must always be in place when the
griddle is turned on.
Move griddle
plate to the side
and turn leveling
screws
Move griddle
plate to the side
and turn leveling
screws
Move griddle
plate to the side
and turn leveling
screws
Figure 33: Leg Covers
Figure 34: Range Dimples
'LPSOHV
Page view 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 93 94

Comments to this Manuals

No comments