Thermador PRD484NCGU Installation Manual Page 21
- Page / 94
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
English 18
3-Wire Lead Connection
Where local codes and ordinances permit grounding
through neutral, and conversion of supply to 4 wire is
impractical, unit may be connected to the power supply
with a 3-POLE, 3-CONDUCTOR cord kit rated 125/250
VOLTS, 50 AMPERES, and marked for use with ranges.
The cord kit must be attached to the range back panel with
a strain relief which will fit a 1" (25.4 mm) diameter hole. If
not already equipped, the cord must also have 1/4” (6 mm)
faston closed-loop lugs attached to the free ends of the
individual conductors, preferably soldered in place.
1. Locate the terminal block on the rear of the unit and
remove cover.
2. Mount strain relief (not provided with range) into the 1"
(25.4 mm) diameter hole in the back panel located
below the terminal block (see Figure 17). Route wires
up through strain relief.
3. Remove upper nuts only from the terminal block studs.
Do not remove nuts which secure range internal wiring
leads.
4. Secure the neutral, grounded wire of the supply circuit,
to the center stud (silver colored) of the terminal block
(see Figure 19).
5. Secure the L1 (red) and L2 (black) power leads to the
outside corresponding terminal block studs (brass
colored).
6. Secure one end of the mounted looped neutral wire,
located beneath terminal block, to the center stud of
the terminal block with nut and keep the other end of
the wire screwed into the back of the range.
7. Tighten nuts securely.
8. Reinstall the Terminal Block Cover.
INSTALLER — show the owner the location of the circuit
breaker. Mark it for easy reference.
Figure 18: Strain Relief Location
6WUDLQ5HOLHI
7HUPLQDO
%ORFN
Figure 19: 3-Wire Connection
5HG/
:LUH
%ODFN/
:LUH
:KLWH
1HXWUDO:LUH
*URXQG
OLQNSURYLGHG
RQUDQJH
- INSTALLATION MANUAL 1
- MANUAL D’INSTALLATION 1
- MANUAL DE INSTALACIÓN 1
- Table of Contents 3
- IMPORTANT SAFETY INSTRUCTIONS 4
- Installation 6
- Step 2: Cabinet Preparation 7
- Installation Clearances 8
- 36" (914 mm) min 10
- Gas and Electric Supply Zones 11
- Electrical Supply 11
- Step 3: Unpacking and Moving 12
- Figure 6: Door Trim Removal 13
- Adjustment 14
- Step 4: Door Removal and 14
- Step 5: Installing Anti-Tip 15
- Mounting the Anti-Tip Bracket 16
- Step 6: Gas Requirements and 17
- 4-Wire Connection 20
- 3-Wire Lead Connection 21
- (optional) 22
- wBOEw 22
- BOENN 22
- wNN 22
- (KHS [30, 36, 42, 48] QS) 24
- Backguard Installation 25
- High Shelf Assembly 26
- Step 9: Placing and Leveling 27
- English 25 28
- Installing the Leg Covers 29
- Data Rating Label 30
- Step 10: Burner Test 31
- Installer Final Check List 32
- Table des matières 33
- CONSIGNES DE SÉCURITÉ 34
- Vérification du type de GAZ 35
- Approvisionnement en gaz: 35
- Alimentation électrique 35
- Renseignements de 36
- Étape 1 : Exigences en 36
- Étape 2 : Préparation des 37
- 36 po (914mm) min 40
- Modèle A B C D 41
- Étape 3 : Déballage et 42
- Retrait de la porte 44
- Réinstallation de la porte 44
- Étape 5 : Installation du 45
- =21(*$6 46
- Raccordement 47
- Connexion Permanente 49
- Connexion à quatre fils 50
- Connexion à trois fils 51
- Étagère garde-chaud 54
- (KHS [30,36,42,48] QS) 54
- Installation du dosseret 55
- Étape 9 : Mise en place et 57
- Assemblage du gril 59
- Plaque signalétique 60
- Étape 10 : Test des brûleurs 61
- Índice de materias 63
- Instrucciones de Seguridad 64
- Verificación del tipo de gas 65
- Suministro de gas: 65
- Alimentación Eléctrica: 65
- Paso 2: Preparación de los 67
- (305 mm) 68
- 36" (914 mm) 69
- Modelo A B C D 71
- Paso 3: Desempacar y mover 72
- Paso 5: Instalación del 75
- =RQD*DV 76
- (OpFWULFR 76
- Paso 6: Requisitos de gas y 77
- Conexión Permanente 79
- Conexión de 4 cables 80
- Conexión de 3 cables 81
- Paso 8: Instalación de la 82
- Estante guarda-caliente 84
- Ensamblaje del estante alto 86
- Paso 9: Colocar y nivelar la 87
- Español 25 88
- (con algunos modelos) 89
- Ensamblaje de la parrilla 89
- Placa de señalización 90
- Paso 10: Pruebas de los 91
- THERMADOR 94
Related products and manuals for Cookers Thermador PRD484NCGU
Cookers Thermador PODM301J User Manual
(108 pages)
(108 pages)
Cookers Thermador MES301HS User's Guide
(28 pages)
(28 pages)
Cookers Thermador PRD606RCSG User's Guide
(47 pages)
(47 pages)
Cookers Thermador WD30JS User's Guide
(17 pages)
(17 pages)
© 2020, manymanuals.com. All rights reserved. | 0.944 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals