Thermador HMCB36WS Installation Guide download pdf (Page 12)

Installation InstructionsEnglish | 12 |

CommonDuctingCongurations

RECIRCULATING MODE VENTING THROUGH THE WALL VENTING THROUGH THE CEILING

A. 8” round transition

B. 8” round duct system

C. 90° elbow

D. Recirculating kit

E. Installation height:

Gas range MIN: 30” (76.2 cm)

Electric range MIN: 30” (76.2 cm)

NOTE: Theguredoesnotrepresentallcongurationsorinstallationmethods.TheimageistobeusedasaguideONLY.

Venting Methods

This hood is factory set for venting through the roof (vertical

discharge) or wall (horizontal discharge). A 8” (203 mm)

round duct system is needed for installation (not included).

NOTE: Flexible duct is not recommended. Flexible

ductwork creates back pressure and air turbulence that

greatly reduce performance.

Vent system can terminate either through the roof or wall.

Always install a metal vent cover where the ductwork exits

the house.

For Non-Vented (recirculating) Installations

If it is not possible to vent cooking fumes and vapors to

the outside, the hood can be used in the non-vented

(recirculating) version, using the recirculating kit . Fumes

and vapors are recycled through the round grid.

See optional accessories section.

Hood Transition

Vertical Discharge Transition

The hood is shipped ready for vertical discharge.

The transition supplied with the hood connects to standard

8"(203mm)roundduct.Thegureshowsthetransition

connected for vertical discharge.

⁄

(345)

(177)

⁄

”

(120)

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 59 60

No comments

Thermador HMCB36WS Installation Guide Page 12