Thermador Cooktop SGSL User Manual download pdf (Page 9)

English 6

installed on the manifold pipe, the conversion nut will be

easily accessible.

CAUTION:

Do not attempt any adjustment of the pressure

regulator, except conversion to propane.

Connect the gas supply line to the unit pressure regulator

using a 1/2" flex gas line connector between manual shut-

off valve and pressure regulator. Always use a new flex

line.

Check supply line connections for leaks using a soap

solution. Do not use a flame of any sort.

1. Turn on gas.

2. Apply a non-corrosive leak detection fluid to all joints

and fittings in the gas connection between the shut-off

valve and the range. Include gas fittings and joints in

the range if connections may have been disturbed

during installation. Bubbles appearing around fittings

and connections indicate a leak.

3. If a leak appears, turn off supply line gas shut-off valve

and tighten connections.

4. Retest for leaks by turning on the supply line gas shut-

off valve. When leak check is complete (no bubbles

appear), test is complete.

5. Wipe off all detection fluid residue.

Important Notes for Gas Connection:

 The appliance and its individual gas shutoff valve must

be disconnected from the gas supply piping system

during any pressure testing of that system at test

pressures in excess of 1/2 psig (3.5kPa).

 The appliance must be isolated from the gas supply

piping system by closing its individual manual shut-off

valve during any pressure testing of the gas supply

piping system at test pressures equal to or less than 1/

2 psi (3.5kPa).

Connect Electrical Supply

Before connecting 5-foot (1.5 m) supply cord to wall

receptacle, make certain that gas shutoff valve and all

burner controls are in OFF position.

Burner Cap Placement

WARNING:

To prevent flare-ups, do not use the cooktop

without all burner caps and all burner grates

properly positioned.

WARNING:

To prevent burns, do not touch burner caps or

grates while hot. Turn the cooktop off and allow

the burners to cool.

The burner caps must be properly placed for the cooktop to

function properly. If the burner cap is not properly placed,

one or more of the following problems may occur:

 Burner flames are too high.

 Flames shoot out of burners.

 Burners do not ignite.

 Burner flames light unevenly.

 Burner emits gas odor.

Placing Burner Caps

Each cap has a letter (B, D, or F) cast in the underside of

the cap that corresponds to a letter (B, D, or F) cast in the

burner base that is attached to the appliance.

 After electrical connection is complete, place each

burner cap on its correct burner base per its

corresponding letter designation.

Figure 7: Pressure Regulator

Figure 8: Gas and Electrical Location

1/2”

Female Pipe

Threads

Receptacle

Supply Cord

120 V

C of Wall

Flex Gas Line

Rough-in Box

Pressure

Regulator

Shows

Direction of

Gas Flow

Gas Shut-Off Valve

Cabinet Floor

Gas Stubout

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

Comments to this Manuals

No comments

Thermador Cooktop SGSL User Manual Page 9

Comments to this Manuals

Related products and manuals for Cookers Thermador Cooktop SGSL