Thermador Cooktop SGSL User Manual download pdf (Page 6)

English 3

Installation

Before You Begin

Tools and Parts Needed

1. Phillips Head Screwdriver

2. Drill with 1/4” (6.5mm) bit

3. Tape Measure

4. Teflon Tape (Gas Rated)

Parts Included

1. Foam tape

2. Hold down brackets (4)

3. Screws, #10-32 x 2 1/2” (63.8mm) (4)

4. Sheet Metal Screws, #8 x 3/8” (9.5mm) (4)

5. Washers (4)

6. Burner Grates (3)

7. Burner Caps

36” models: (5)

30” models: (4) or (5)

8. Pressure Regulator

If parts are missing or damaged, call the number or write to

the address listed inside the back cover.

General Information

Overall Dimensions

* NOTE: These are overall dimensions NOT cutout

dimensions.

Preparation

Electrical Requirements

This appliances requires a 60 Hz, 15 Amp, 120 VAC

connection. Plan the installation so that the power

connection is accessible from the front of the cabinet.

Gas Requirements

Supply Pressure:

 Natural Gas - 7 inches water column (14.9 Millibars)

minimum.

 Propane Gas -11 inches water column (27.4 Millibars)

minimum.

The propane gas tank must be equipped with its own high

pressure regulator in addition to the pressure regulator

supplied with this unit. The cooktop is shipped from the

factory for use with natural gas. For use with LP conversion

kit – Model SNLPKITF, must be purchased separately. A

qualified technician or installer must do the conversion.

Cabinet Requirements

Dimension requirements in Figures 1 and 2 are for

combustible surfaces. When the surface is protected by a

material listed by UL as a Floor Protector and Wall Shield

covered with not less than No. 28 MSG sheet metal 0.015

inch (0.38mm) stainless steel, 0.024 inch (0.6mm)

aluminum or copper, it is considered noncombustible and

some dimensions may be reduced. For a noncombustible

surface over the cooktop, the minimum clearance is 24"

(61cm) rather than 30" (76cm).

 Instructions are based on standard American cabinets

36" high (91cm) x 24" deep (61cm) with a 25" (63cm)

countertop.

 Provide approximately a 10 square inch opening

(65cm

) in the toe kick area or other cabinet area for

adequate air inlet to the cabinet if installed with a

downdraft.

 The maximum depth of cabinet installed above cooktop

is 13” (33cm).

30” Models 36” Models

Width

(Side to Side)

31” (788 mm) 37” (940 mm)

Depth

(Front to Back)

21 1/4” (540

mm)

21 1/4” (540

mm)

Height

(Top to Bottom)

3 13/16 (97 mm) 3 13/16 (97 mm)

1 2 3 4 5 6 7 8 9 10 11 ... 35 36

Comments to this Manuals

No comments

Thermador Cooktop SGSL User Manual Page 6

Comments to this Manuals

Related products and manuals for Cookers Thermador Cooktop SGSL