Thermador Cooktop SGSL User Manual download pdf (Page 8)

English 5

Prepare the Countertop

Cut out the countertop per the dimensions shown in

“Cabinet Requirements” on page 3.

Some solid surface materials, such as Surell™ and

Corian®, require different cutting methods. Consult with the

solid surface manufacturer for the correct cutting method

needed. Apply heat reflective tape such as Scotch

Aluminum Foil Tape #425 or #427 (not included) around the

cutout so that it folds over on the top and sides. Do not

wrap the tape underneath the cooktop. Be sure the tape

extends beyond the outermost flange of the cooktop. All

corners should be covered with tape.

Seal the Cooktop with Foam Tape

Apply the self adhesive foam tape in one continuous

rectangle directly to the counter around the perimeter of the

cutout as shown by the dotted line in Figure 4: “Counter

Cutout – Foam Tape Placement”. Leave 1/4” (6.35mm) gap

between the foam tape and the edge of the cutout.

Install the Cooktop

Insert cooktop into the cutout. Attach clamps of the hold-

down brackets packaged with the cooktop to the rough-in

box. Use the washer and screws provided.

Adjust hold-down brackets to desired position and tighten

screws to rough-in box. Insert adjusting screw into clamp

and secure cooktop to countertop.

NOTE:

For solid surface material installations: Insert a wooden

block between the end of the screw and the bottom of the

countertop. Do not overtighten adjusting screw. Trim

excess aluminum tape around cooktop flange.

Connect Gas Supply

The gas inlet to the unit is located at the right rear of rough-

in box.

Install the pressure regulator (supplied with unit) to

manifold pipe using Teflon tape on threads of manifold

pipe. Turn to hand tighten plus 1/4 turn, not exceeding 1

turn for alignment. To prevent possible damage to the gas

pressure regulator, install it after the rough-in box is in its

permanent position. When the regulator is securely

Figure 3: Counter Cutout – Solid Surface Countertops

Figure 4: Counter Cutout – Foam Tape Placement

Heat Reflective Tape

Cutout shows location

of Aluminum Reflective Tape

Section "A - A"

1/4”

(6.35mm)

Cutout

Foam

Tape

Figure 5: Attaching Hold-Down Brackets

Figure 6: Rough-in Box Area

Rough-in Box

Foam

Tape

(Seal)

Adjusting

Screw

Adjusting

Screw

Clamp

Wooden Block

(to be used with

solid surfacing

material, i.e.

Surell™ and

Corian®)

Opening for Gas

Connection and

Electrical Cord

for 30” models: 12 15/16” (313 mm)

for 36” models: 15 15/16” (389 mm)

C of Cutout

1”

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

Comments to this Manuals

No comments

Thermador Cooktop SGSL User Manual Page 8

Comments to this Manuals

Related products and manuals for Cookers Thermador Cooktop SGSL