Thermador PRD48NCSGU Installation Manual download pdf (Page 16)

English 13

Important Installation Information:

• Attach anti-tip bracket to a solid wood cabinet having a

minimum wall thickness of 3/4” (19 mm). The thickness

of the wall or floor may require use of longer screws,

available at your local hardware store.

• Use appropriate anchors when fastening the mounting

bracket to any material other than hard-wood or metal.

• At least (2) of the bracket mounting screws must firmly

fasten the anti-tip bracket to the floor, and (2) of the

mounting screws (or drywall anchors) must firmly

fasten the anti-tip bracket to the rear wall (see

Figure 13 and Figure 14).

Prepare holes at fastener locations as identified below:

•

For walls, wall studs, or floors composed of solid wood

or metal, drill 1/8” (3 mm) pilot holes.

•

For walls or floors composed of drywall, sheet-rock or

other soft materials, drill 3/16” (5 mm) holes to a

minimum depth of 1¾” (45 mm), then tap plastic

anchors into each of the holes using a hammer.

•

For walls or floors composed of concrete or concrete

block, drill 3/16” (5 mm) holes to a minimum depth of

1¾” (45mm), then tap concrete anchors into each of

the holes using a hammer.

•

For walls or floors having ceramic tile covering, drill

3/16” (5 mm) holes through the tile only, then drill into

the material behind the tile as indicated immediately

above.

Mounting the Anti-Tip Bracket

1. Place bracket on floor near the center of where the unit

is to be finally located (Figure 13).

2. Secure bracket into the wall stud using (2) mounting

screws or drywall anchors, as appropriate (Figure 14).

3. Secure the bracket to the floor using the screws

provided (Figure 14).

4. Later, when the unit is installed, the adjustable legs will

allow the cast base to slide under the bracket hook,

stabilizing the unit.

5. If the range is moved to a new location, the Anti-Tip

Bracket must be reinstalled.

WARNING!

ELECTRICAL SHOCK HAZARD:

• Use extreme caution when drilling holes into the wall

or floor as there may be concealed electrical wires.

• Identify the electrical circuits that could be affected

by the installation of the Anti-Tip Device, then turn off

power to these circuits.

• Failure to follow these instructions may result in

electrical shock or other personal injury.

Figure 13: Anti-tip Bracket Mounting Location

Figure 14: Anti-tip Bracket

´

PP

*$6=21(

(/(&75,&$/

=21(

6TFTDSFXTUP

TFDVSFUIFCSBDLFU

UPUIFSFBSXBMM

TUVE

6TFTDSFXTUPTFDVSF

UIFCSBDLFUUPUIFGMPPS

6TFTDSFXTUPTFDVSF

UIFCSBDLFUUPUIFGMPPS

6TFTDSFXTUPTFDVSF

UIFCSBDLFUUPUIFGMPPS

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 93 94

Comments to this Manuals

No comments

Thermador PRD48NCSGU Installation Manual Page 16

Comments to this Manuals

Related products and manuals for Cookers Thermador PRD48NCSGU