Thermador POD302 User Manual download pdf (Page 13)

Electrical Installation

All model ovens on the front cover are dual rated, designed to be connected to ei-

ther 208/240V AC, 60 Hz, 4 wire, single-phase power supply.

The electrical supply should be a 4-wire single-phase AC. Install a suitable conduit

box (not furnished).

Important: Local Codes may vary, installation, electrical connections and ground-

ing must comply with all applicable local codes.

If local codes permit grounding through the electrical supply neutral, connect both

the white neutral wire and the bare ground wire from the oven to the white neutral

electrical supply wire.

Electrical Connection

1. Connect the red oven wire to the red electrical supply wire (hot wire).

2. Connect the black oven wire to the black electrical supply wire (hot wire).

3. Connect the white neutral oven wire to the white neutral (not bare ground)

electrical supply wire.

4. Connect the bare ground oven wire to the bare ground electrical supply wire.

The conduit cable, where connected at the oven, swivels. Rotate conduit cable up-

ward (or downward) and direct through hole prepared in cabinet to attach to J-Box.

To facilitate maintain serviceability, the flex conduit must not be shortened and

should be routed to permit temporary removal of the oven.

Model Circuit Required

208V, 60 Hz 240V, 60 Hz

M271, M301 25 AMP 30 AMP

ME301, MEW301

ME271, PO301,

POD301, DE301,

DEC301

30 AMP 30 AMP

ME302, MED302

ME272, MED272,

PO302, POD302,

PODC302, DE302,

MEM271, MEM301,

POM301, MEMC301,

MEMCW301,

MEMW271, MEMW301,

POMW301

40 or 50 Amp circuit. Refer to local electrical codes

for de-rating requirements.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 43 44

No comments

Thermador POD302 User Manual Page 13