Thermador PRD304GHU User Manual download pdf (Page 16)

English 14

Step 6: Electrical

Requirements, Connection &

Grounding

• Prior to servicing appliance, always disconnect

appliance electrical supply cord, if so equipped, from

wall receptacle. If appliance is hard-wired to power

supply, disconnect power to unit by turning off the

proper circuit breaker or disconnecting the proper fuse.

Lock service panel to prevent power from being turned

ON accidentally.

Dual Fuel range models can be connected or hardwired to

the power supply as described on page 15.

• A neutral supply wire must be provided from the power

source (breaker/fuse panel) because critical range

components, including the surface burner spark

reignition module, require 120 VAC to operate safely

and properly. An improper 120/ 240 VAC power supply

will cause malfunction, damage this appliance, and

possibly create a condition of shock hazard. If the

correct power supply circuit is not provided, it is the

responsibility and obligation of the installer and user to

have proper power supply connected. This must be

accomplished in accordance with all applicable local

codes and ordinances by a qualified electrician. In the

Figure 8: Location of Gas Supply Inlet Connection

on 30” and 36” Ranges

Figure 9: Location of Gas Supply Inlet Connection on 48”

Ranges

Chart B: Electrical Supply Circuit Requirements

MODEL

TYPE

VOLTAGE

CIRCUIT

RATING

FREQUENCY PHASE

30” 240/208 VAC 35 Amps 60 Hz. Single

36” 240/208 VAC 35 Amps 60 Hz. Single

48” 240/208 VAC 50 Amps 60 Hz. Single

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 71 72

No comments

Thermador PRD304GHU User Manual Page 16